蘇州市凱思特模具有限公司

1、窗框應干凈、平整、光滑、大面無劃痕、碰傷，型材無開焊斷裂。

2、五金件要齊全，位置正確，安裝牢固，使用靈活。

3、玻璃密封條與玻璃及玻璃槽口的接觸應平整，不得卷邊、脫槽。

4、門窗半閉時，扇與框之間無明顯縫隙，密封面上的密封條應處于壓縮狀態。

5、 玻璃應平整、安裝牢固，不應有松動現象，單層玻璃不得直接接觸型材，雙層玻璃內外表面均潔凈，沒有灰塵和水汽，隔條不能翹起。

6、帶密封條的壓條必須與玻璃全部貼緊，壓條與型材接縫處應無明顯縫隙，接頭縫隙應小于或等于1毫米。

7、拼樘材應與窗框連接緊密，鋁材**品牌同時用嵌縫膏密封，不得晃動，內襯增強型鋼，兩端均應與洞口固定牢靠。

8、窗戶應關閉嚴密。

9、排水孔位置要正確，同時還要通暢。

1, window frames should be clean, smooth, Omo no scratches, bumps, no profiles on Fracture.

2, the hardware to complete, correct position, securely installed, use and flexible.

3, the contact glass and the glass and the glass seal notch should be smooth, without curling, off slot.

4, the semi-closed doors, no significant gap between the fan and the frame, the sealing surface of the sealing strip should be in a compressed state.

5, the glass should be smooth, firmly installed, there should be no loosening, single glass may not be in direct contact profiles, double glazing and external surfaces are clean and free of dust and moisture, gutter can not tilt.

6, the pressure strip seal must all snapping and glass, layering and profiles seams should be no obvious cracks, joints gap should be less than or equal to 1 mm.

7, fight tang timber should be closely connected with the sash, while the top ten brands of aluminum sealed with caulk, can not shake, lined reinforced steel, with openings at both ends shall be fixed firmly.

8, the windows should be closed tightly.

9, the drainage hole to the right, but also smooth.